CHAPTER 103
POST-CONSTRUCTION EROSION
AND SEDIMENT CONTROL

103.01 Purpose and Intent	103.12 Compensatory Action
103.02 Inspection of Storm Water Management Features	103.13 Violations Deemed a Public Nuisance
103.03 Right of Entry for Inspection	103.14 Municipal Infraction
103.04 Requirements for Maintenance	103.15 Remedies Not Exclusive
103.05 Records of Installation and Maintenance Activities	103.16 Compatibility with Other Requirements
103.06 Failure to Maintain Drainage Features	103.17 Ultimate Responsibility
103.07 Notice of Violation	103.18 Stop Work Orders
103.08 Appeal of Notice of Violation	103.19 Enforcement and Penalties; Violations
103.09 Enforcement Measures After Appeal	103.20 Restoration of Lands
103.10 Violations	103.21 Hold of Occupation Permits
103.11 Injunctive Relief

 

103.01 PURPOSE AND INTENT.

The purpose of this chapter is to establish erosion, sediment controls, and inspection procedures for controlling the introduction of pollutants to the Municipal Separate Storm Sewer System (MS4) from developed or redeveloped properties. Post-construction storm water inspections are limited to developed sites of one acre in size (43,560 square feet) or greater. The City Engineer herein grants an exemption to post-construction inspections for sites less than one acre, given the amount of impervious surface created is not in excess of 11,000 square feet (approximately ¼ acre).

103.02 INSPECTION OF STORM WATER MANAGEMENT FEATURES.

   1.   The City Engineer or an authorized representative shall establish and maintain a storm water inspection schedule that includes (but is not limited to):

      A.   Routine inspections;

      B.   Random inspections;

      C.   Inspections based upon public complaints;

      D.   Inspections based upon notice of possible violation;

      E.   Inspection of areas identified as having a higher than typical potential for sediment or pollutant exposure, such as construction sites, detention and retention basins;

      F.   Inspections of businesses or industries of a type associated with discharges that are more likely than the typical discharge to cause violations of State or Federal water or sediment quality standards, or the National Pollutant Discharge Elimination System (NPDES) Phase II storm water permit and the Clean Water Act; and

      G.   Joint inspections with other agencies inspecting under environmental or safety regulations as deemed necessary.

   2.   Inspections may include (but are not limited to) the following:

      A.   Evaluating the condition and current need for maintenance of storm water control features such as inlets, manholes, piping, detention, and retention basins;

      B.   Sampling discharges, surface water, groundwater, sediment material or standing water in drainage control facilities as deemed necessary;

      C.   Reviewing maintenance and repair records of storm water facilities;

      D.   Verification that storm water facilities, approved during construction plan review, such as detention basins, retention basins, piping and inlets are present and in good condition.