§ 72.406 FINAL PLAT

   (A)   The final plat shall be drawn in ink on tracing cloth or equally durable material that is eighteen inches by twenty-two inches (18” x 22”) or thirty-six inches by forty-four inches (36” x 44”) and shall be at a scale of either fifty feet (50’) to the inch or one hundred feet (100’) to the inch. Where necessary, the plat may be on several sheets accompanied by an index sheet showing the entire subdivision. For large subdivision, the final plat may be submitted for approval progressively in contiguous sections satisfactory to the Planning Commission. The final shall show the following:

      (1)   Primary control points, approved by the County Engineer, or descriptions and “ties” to such control points, to which all dimensions, angles, bearings, and similar data on the plat shall be referred;

      (2)   Tract boundary lines, right-of-way lines of streets, easements, and other rights-of-way and property lines of residential lots and other sites; with dimensions in feet and hundredths of a foot, bearings, or deflection angles, and radii, arcs, and central angles of all curves;

      (3)   Location, size, and invert elevation of all sanitary, storm, and combined sewers and the location of all manholes, inlets, and culverts;

      (4)   Name and right-of-way width of each street or other right-of-way;

      (5)   Location, dimensions, and purpose of any easements;

      (6)   Number to identify each lot or site;

      (7)   Purpose for which sites, other than residential lots, are dedicated or reserved;

      (8)   Minimum building setback lines on all lots and other sites;

      (9)   Location and description of monuments; one (1) to be placed at each corner and at each change in direction of the boundary; two (2) to be placed at each street intersection; and one (1) at the beginning and end of curves on one (1) side of the street;

      (10)   Names of record owners of adjoining unplatted land;

      (11)   Reference to recorded subdivision plats of adjoining platted land by record name, date and number;

      (12)   Certification by surveyor or engineer certifying to accuracy of survey and plat;

      (13)   Name and address of the owner; certification of title showing that applicant is the landowner or his authorized agent;

      (14)   Statement by the owner dedicating streets, rights-of-way and any sites for public use;

      (15)   Notation stating title, acreage, number of lots, and key map sowing the location of tract, graphic scale, north point, and date;

      (16)   Signature blocks for:

         (a)   The City Engineer;

         (b)   The Chairman and one (1) member of the Planning Commission; and

      (17)   Any additional items required by § 72.404.

(Ord. passed 11-14-72)

______________

Cross reference:

   Fees due upon submission of final plat, see § 72.502

§ 72.407 CROSS SECTION; PROFILES

   Cross sections and profiles of streets, as approved by the City Engineer, including existing and proposed grades and culvert locations with invert elevations and sizes. The profiles shall be drawn to city standard scales and elevations, and shall be based on a datum approved by the City Engineer.

(Ord. passed 11-14-72)

§ 72.408 CERTIFICATE BY CITY ENGINEER

   A certificate by the City Engineer shall be issued certifying that the subdivider has complied with one (1) of the following alternatives:

   (A)   All improvements have been installed in accord with the requirements of this chapter; or

   (B)   A bond or certified check has been posted, which is available to the city, and in sufficient amount to assure the completion of all required improvements.

(Ord. passed 11-14-72)