(a) No part of a projecting sign shall be supported from an unbraced parapet wall. All metal parts used in sign or structure, including pole or pylon, metal, supports and braces, shall be galvanized or of corrosive-resistant material or painted with approved corrosive-resistant paint. When existing poles or structures are used for new sign installation, all parts shall be brought to like-new condition and shall be painted with approved rust and corrosion-resistant paint. Existing pole and installation of pole shall be approved before being used in new sign installation.
(b) When a sign is removed for any reason, a new permit for future installation of the sign shall be obtained. All mast arms, cable, guys of any nature, clips, brackets and all structures of the old sign shall be removed with the sign.
(c) No equipment such as cable to support electric circuits, light fixtures, guys, etc. may be added to sign structure or supports other than as approved the Building Inspector in the sign permit. Brackets, wires, switches, etc. required to illuminate the sign may be added. When sign structure or supports are used in any manner other than outlined above, certification by a licensed engineer shall be obtained to show structure is capable of supporting the load.
(d) Projecting signs, such as marquee signs, shall not be installed on a building or structure unless the support has been designed specifically for the purpose of supporting a sign and approved by the Building Inspector. Projecting sign surface area is limited to eight square feet and must be a least 10 feet above ground level, but is not permitted to extend over streets, easements or rights of way.
(e) No sign or outdoor display structure shall be erected, constructed or maintained so as to create a traffic hazard by obstructing or confusing the view of traffic lights, railroad crossing lights or warning signs. No sign or outdoor display structure shall be of such character or with such inscription or marking that it may be mistaken for a highway sign or marker. No sign of any description shall be installed, erected or constructed in such a manner as to obstruct any fir escape, nor shall a sign be attached in any form, shape or manner to a fire escape.
(f) No revolving or flashing lights or beacons of any kind shall be used on any type sign.
(g) All electrical signs shall be plainly marked on the bottom edge of the sign using ¾ inch minimum letters with the erector’s name, the voltage, amperes or watts, and the date of installation. All signs shall be grounded.
(h) All skeleton tubing installed outside shall be backed with metal, masonry or a noncombustible material unless mounted on three-inch tube supports.
(I) All wiring, fittings and materials used in the construction, connection and operation of electrically illuminated signs shall be in accordance with the provisions of the National Electric Code. Electric sign wiring shall be maintained in weatherproof condition during erection or alteration by use of permanent or temporary cover.
(j) Pole size for monument signs shall be of sufficient size to support a thirty-pound per square foot wind pressure against face of sign. The Center Ohio Sign Association’s most current specification charts and tables for determining size of supporting steel and concrete foundation of ground-supported signs is hereby adopted as minimum requirements.
(k) No sign is to be erected until the excavation for foundation or foundations has been inspected and a permit application with drawing to comply with the table for depth has been submitted and approved.
(l) Materials for the primary base and supporting structures for all new, replacement, or reconstructed monument signs will consist of brick, stone, or other masonry material approved by the Building Department, or a treated wood accepted by the Building Department.
(Ord. 36-03. Passed 5-19-03.)