The Final Plat shall contain the following:
(a) Title: Name of Subdivision
Lot Number
Township - Section
Scale 1" equals 100' or less
Date
(b) North point.
(c) Boundary of plat, based on an accurate traverse, with angular and lineal dimensions. The survey error of closure shall not exceed 1:25,000.
(d) A table showing the total acreage contained in subdivision, the acreage in lots and the acreage in roads. If the subdivision is in two lots, then the above mentioned acreage shall be shown for each lot.
(e) Exact location, width, and name of all roads within and adjoining the plat, and the exact location and width of all alleys and crosswalks.
(f) True angles and distances to the nearest established road lines and official section monuments which shall be accurately described on the plat.
(g) Municipal, township, county or lot lines accurately tied to the lines of the subdivision by distances and angles.
(h) Radii, internal angles, points of curvature, tangent bearings, lengths of all arcs, and lengths and bearings of all chords.
(i) All easements for right of way provided for public services or utilities.
(j) All log numbers and lines with accurate dimensions in feet and hundredths.
(k) Provide location of permanent monuments on the boundary and streets; and iron pins at each lot corner.
(l) The plat shall show any or all easements of right of way when provided or owned by public utilities and any areas to be dedicated or reserved for public use, or any area to be reserved by deed covenant for common use of all property owner.
(m) Building setback lines accurately shown with dimensions.
(n) Certification by registered surveyor to the effect that the plat represents a survey made by him and that the monuments shown thereon exist as located and that all dimensional and geodetic details are correct.
(Sec. 711.04, ORC)
(o) Notarized certification by the owner or owners of the adoption of the plat and the dedication of streets and other public areas.
(Sec. 711.04, ORC)
(p) Signatures of the following officials signifying approvals in accordance with their respective responsibilities are required on a copy of the final plat a sample of which is included in the Appendix of these Regulations.
(1) Approval of plat by the City and Planning Commission.
(2) Approval of plat by City Engineer.
(3) Approval of roads by County Engineer.
(4) Approval of Secretary of County Zoning Commission in those townships having zoning.
(5) Proper notations for transfer and recording by the County Auditor and the County Recorder.
(q) Construction Plans. For all roads to be constructed in the allotment, a plan and profile of each road, drawn on Standard Federal Aid Sheets or equal, shall accompany the final plat. Scale to be used: Horizontal 1" equals 50'; Vertical 1" equals 5'. Linen FAS Sheets and India ink or mylar and mylar pencil shall be used. Sea level (USGS) datum shall be used. In addition, a general utility plan showing all rights of way, utilities and roads shall be provided at a scale of 1" = 100' on 24" x 36" size. Additional details, typical sections, grading plan, cross- sections, general notes, quantities and calculations shall be provided.
(Ord. 82-16. Passed 4-19-82.)