(a) Permanent monuments shall be accurately set and established at the intersection of all outside boundary lines of the plat. Monuments shall be concrete not less than three feet long and four inches square or round at the top with a round iron pin the full length of the monument set in center, or of some other type approved by the Engineering Department. Iron pins shall also be set at the intersection of the centerline of all streets after paving operations are complete.
(b) Solid iron pins of no less than 1/2” diameter or hollow iron pins of no less than 3/4” diameter and 30 inches long shall be set at the corners of all lots, at the points of curvature and tangency, at the center of all street intersections, at radius points, points of curvature of reverse curves, at points where side lot lines curve or deflect, and at such other points as are necessary to definitely establish all lines of the plat.
(c) Iron pins and monuments removed or destroyed during installation of permanent improvements by the subdivider or his contractor shall be replaced by the subdivider at his expense. All iron pins shall be in place prior to construction on a particular lot.
(Ord. 1166. Passed 9-24-01.)