The final plat prepared for recording purposes shall be prepared in accordance with provisions of state statutes and county regulations and shall contain the following information:
(A) Name of subdivision. Name shall not duplicate or too closely resemble the name of any existing subdivision;
(B) (1) Location of subdivision. Location shall be given by section, township, range, county and state, and shall include descriptive boundaries of the subdivision, based on an accurate traverse, giving angular and linear dimensions which must mathematically close.
(2) The allowable error of closure on any portion of a final plat shall be 1 foot in 5,000;
(C) (1) The location of monuments shall be shown and described on the final plat.
(2) Locations of monuments shall be shown in reference to existing official monuments or the nearest established street lines, including true angles and distances to the reference points or monuments.
(3) Permanent markers shall be placed at each corner of every lot and every block or portion of a block, point of curvature and points of tangency on street lines, and at each angle point on the boundary of the subdivision.
(4) A PERMANENT MARKER is deemed to be a steel rod or pipe, 1/2 inch or larger in diameter extending at least 3 feet below the finished grade.
(5) In situations where conditions prohibit the placing of markers in the locations prescribed above, offset markers will be permitted.
(6) The exact location of all markers shall be shown on the final plat, together with accurate interior angles, bearings and distances.
(7) Permanent monuments shall be placed at all quarter section points within the subdivision or on its perimeter;
(D) (1) Location of lots, streets, public highways, alleys, park and other features, with accurate dimensions in feet and tenths of feet, with the length radii and/or arcs of all curves, and with all other information necessary to reproduce the plat on the ground.
(2) Dimensions shall be shown from all angle points of curve to lot lines;
(E) Lots shall be numbered clearly. If blocks are to be numbered or lettered, these should be shown clearly in the center of the block;
(F) The exact locations, width and names of all streets to be dedicated;
(G) Location and width of all easements to be dedicated;
(H) Boundary lines and description of boundary lines of any areas other than streets and alleys which are to be dedicated or reserved for public use;
(I) Building setback lines on front and side streets with dimensions;
(J) Name and address of developer and surveyor making the plat;
(K) Scale of plat (to be shown graphically and in feet per inch), date and north point;
(L) Statement dedicating all easements as follows: easements for installation and maintenance of utilities and drainage facilities are reserved over, under and along strips marked utility easements;
(M) Statement dedicating all streets, alleys and other public areas not previously dedicated as follows: streets, alleys and other public areas shown on this plat and not heretofore dedicated to public use are hereby so dedicated; and
(N) Statement establishing building setback lines as follows: building setback lines are hereby established as shown on the accompanying plat and no building or portion thereof shall be built between this line and the street line.
(1985 Code, § 1302.07)