The location and arrangement of land and structures within the manufactured home park shall be determined in accordance with the following standards:
(A) The manufactured home park shall be developed with accessways of not less than 30 feet in width and shall be paved for not less than 20 feet. Such pavement shall be constructed of not less than six inches of an impervious pavement material on a prepared subgrade.
(B) There shall be common walks three feet or more in width either within the accessway or along mobile home site boundaries. Such walks shall be constructed of not less than four inches of an impervious pavement material on a prepared subgrade.
(C) Each manufactured home site shall be not less than 6,000 square feet and shall be not less than 60 feet in width.
(D) Each manufactured home site shall have paved strips or a pad for the mobile home in compliance with the following standards:
(1) Strips shall be five inches thick and 30 inches wide and shall run the total length of the unit. In addition, the area between the strips shall be filled with gravel to the depth of three inches of #46D. The concrete shall have a compressive strength of 3,000 psi and shall be reinforced with 6x6 #10 reinforcing wire mesh.
(2) Pads shall be four inches thick and shall extend under the total length and width of the unit. It shall be constructed as specified in subsection (1) above.
(E) Each manufactured home site shall be provided with a water outlet connected to an approved water supply and a connection to an approved sewer system.
(F) Each manufactured home site shall be developed with a paved area (patio) of not less than 180 square feet. The patio shall be of not less than four inches of Portland cement or other rigid type of impervious pavement, and shall be connected to common walks by a similarly paved walk of not less than two feet in width.
(G) Each manufactured home site shall be provided with off-street parking as required by this chapter. Such parking shall be constructed of not fewer than six inches of an impervious pavement material on a prepared subgrade.
(H) Each manufactured home site shall be landscaped to provide a minimum of one non-water seeking tree per site as approved by the Zoning Inspector.
(I) Each manufactured home, within, ten days after placement, shall be securely anchored as required by the manufacturer's recommendations. Individual anchors shall be attached in a manner to assure that the device into which the anchor is attached at ground level is embedded in concrete piers at least six inches in diameter and at least six inches below the normal frost line, however, not less than 36 inches. In lieu of concrete piers, six inch auger anchors may be used, provided they meet the manufacturer's recommendations and are embedded below the normal frost line but not less than 36 inches.
(J) The park operator shall require each unit to install skirting around all sides of the unit within 30 days after placement. The design of skirting for each unit shall be subject to approval by the Zoning Inspector. All skirting shall be of such nature that it will be an asset to the park and the design shall conform with the general architectural character of the manufactured home unit. Bales of straw and rough finish insulation board shall not be used as skirting. Any skirting that is not purchased through regular manufactured home supply sources and fabricated by or for the resident of the unit shall be subject to specific approval in compliance with the standards of this section by the Zoning Inspector.
(K) If mail is to be delivered to a common area, the collection area shall be provided at the entrance to the manufactured home park and a hard surface area entirely off the roadway shall be, provided for mail pick-up and delivery.
(Ord. 6-1993, passed 3-8-93)