(A) The owner of any property serviced by a building sewer carrying industrial wastes shall provide laboratory measurements, tests and analyses of waters and wastes to illustrate compliance with this Chapter and any special conditions for discharge established by the Village, Sanitary District or regulatory agencies having jurisdiction over the discharge. The number, type and frequency of laboratory analyses to be performed by the owner shall be as stipulated by the Sanitary District, but no less than once per year the industry must supply a complete analysis of the constituents of the wastewater discharge to assure that compliance with the Federal, State and local standards are being met. The owner shall report the results of measurements and laboratory analyses to the Village and Sanitary District at times and in a manner as prescribed by the Village and Sanitary District. At times as deemed necessary, the Village or Sanitary District reserves the right to take measurements and samples for analysis by an outside laboratory service.
(B) All measurements, tests and analyses of the characteristics of waters and wastes to which reference is made in this Chapter shall be determined in accordance with the latest edition of IEPA Division of Laboratories Manual of Laboratory Methods, and shall be determined at the control manhole provided, or upon suitable samples taken at the control manhole. In the event that no special manhole has been required the control manhole shall be considered to be the nearest downstream manhole in the public sewer to the point at which the building sewer is connected. Sampling shall be carried out by customarily accepted methods to reflect the effect of constituents upon the sewage works and to determine the existence of hazards to life, limb and property. The particular analyses involved will determine whether a 24-hour composite of all outfalls of a premises is appropriate or whether a grab sample or samples should be taken. Normally, but not always, BOD and suspended solids analyses are obtained from 24-hour composites of all outfalls, whereas pH's are determined from periodic grab samples.
(Ord. 89-11-720, passed 11-2-89)