(A) One signed Mylar plat, two paper copies, one reduced eight and one-half inches by 11 inches copy and an electronic PDF and DWG file shall be submitted to the Planning Director for review and approval. If the plat is not approved by the Planning Director within ten days of submittal, the plat shall be presented to the Board of County Commissioners for action. If more than two sheets are required, an index sheet of the same dimension shall be attached and filed. No work shall be done on the subdivision including the making of any road improvements or installation of any utilities, and no lots sold before the final plat is approved and recorded.
(B) The plat shall contain the following information:
A. | The name of the proposed subdivision and locations by quarter section, section, township, and range. Subdivision names shall not duplicate, be the same spelling, or alike in pronunciation with any existing subdivision located in the same section, unless it is an extension of or adjoining an existing subdivision. Each plat shall be titled as follows:
(Name) Addition in the quarter, section , T N, R W of the 5th P.M. of the county. |
B. | Scale and north arrow. |
C. | The names of all adjacent subdivisions. |
D. | A systematic lot and block numbering pattern, lot lines and road names, and the square footage or acreage of all lots. |
E. | The location and width of all proposed and existing rights-of-way, easements, and private roadways. |
F. | The boundary lines of the area being subdivided with accurate angles or bearings and distances tying the perimeter boundaries to the nearest established street line, section corner, other previously described subdivision, or other recognized permanent monuments which shall be accurately described on the plat as required by SDCL §§ 43-18, 43-20, and 43-21. |
G. | Location of all monuments and permanent control points, and all survey pins, either set or located as required by SDCL §§ 43-18, 43-20, and 43-21. |
H. | The location and description of any portions of the property intended to be dedicated or granted for public use. |
I. | All dimensions, both linear and angular, necessary for locating the boundaries of the subdivision lots, roads, easements and type of easement, and any other areas for public or private use. Linear dimensions are to be given to the nearest 1/100 of a foot. |
J. | The radii, chords, length of curve, points of tangency, and central angles for all curvilinear roads and radii for rounded corners. |
K. | The boundary lines of the floodway and 100-year flood zones, along with the base flood elevation on each lot as delineated on the flood insurance rate maps (FIRM) or as amended by letter of map revision (LOMR). |
L. | Acknowledgment of the owner or owners of the plat of any restrictions, including dedication to public use of all roads, alleys, parks, or other open spaces shown thereon and the granting of easements required. |
M. | All formal irrevocable offers of dedication for all roads and other uses as required. |
N. | Protective covenants or deed restrictions shall be filed with the County Register of Deeds. |
O. | |
P. | Approved assurance agreement(s). |
(Ord. 1104-63, passed 4-26-2011)