Skip to code content (skip section selection)
(A) The final plat prepared for recording purposes shall be prepared in accordance with provisions of state statutes and applicable city and county regulations.
(B) The name of subdivision shall not duplicate or too closely approximate the name of any existing subdivision.
(C) The location by section, township, range or mineral survey number, county and state shall include descriptive boundaries of the subdivision, based on an accurate traverse, giving angular and linear dimensions which must be mathematically close. The allowable error of closure on any portion of a final plat shall be one foot in 7,500 feet.
(D) The location of monuments shall be shown and described on the final plat. Locations of the monuments shall be shown in reference to existing official monuments or the nearest established street lines, including true angles and distances to the reference points or monuments. Permanent markers shall be placed at each corner of every block or portion of a block, at points of curvature and points of tangency on street lines, and at each angle point on the boundary of the subdivision. A permanent marker shall be deemed to be a steel rod or pipe, one-half-inch or larger in diameter, extending at least three feet below the finished grade. In situations where conditions prohibit the placing of markers in the locations prescribed above, offset markers shall be shown on the final plat, together with accurate interior angles, bearings and distances.
(E) Permanent monuments shall be placed at all quarter section points within the subdivision or on its perimeter.
(F) Locations of lots, streets, public highways, alleys, parks and other features with accurate dimensions in feet and decimals of feet, with the length of radii and/or arcs of all cures, and with all other information necessary to reproduce the plat on the ground. Dimensions shall be shown from all angle points and points of curve to lot line.
(G) Boundary lines and description of boundary lines of any areas other than streets and alleys which are to be dedicated or reserved for public use shall be included.
(H) Lots shall be numbered clearly. If blocks are to be numbered or lettered, these shall be shown clearly in the center of the block.
(I) The name and address of developer and surveyor making the plat shall be included.
(J) Scale of plat (the scale to be shown graphically and in feet per inch), date and north point shall be included.
(K) A statement dedicating all easements shall be included as follows: Easements for installation and maintenance of utilities and drainage facilities are reserved over, under and along the strips marked "utility easements".
(L) Statement dedicating all streets, alleys and other public areas not previously dedicated shall be included as follows: streets, alleys and other public areas shown on this plat and not heretofore dedicated to public use are hereby so dedicated.
(Prior Code, § 4-807)