11-101-9: ESTABLISHMENT OF ZONING DISTRICTS:
   A.   Floodway Subdistricts: The area within the FP floodplain overlay district is further divided into three (3) districts:
      1.   FW, Floodway District: The floodway district shall include those areas designated as floodway on the flood insurance rate map adopted in subsection 11-101-7B of this chapter.
      2.   FF, Flood Fringe District: The flood fringe district shall include those areas designated as floodway fringe on the flood insurance rate map adopted in subsection 11-101-7B of this chapter as being within zone AE but being located outside of the floodway.
      3.   GFD, General Floodplain District: The general floodplain district shall include those areas designated as zone A and zone AE without a floodway on the flood insurance rate map adopted in subsection 11-101-7B of this chapter.
   B.   Compliance: No new structure or land shall hereafter be used and no structure shall be constructed, located, extended, converted, or structurally altered without full compliance with the terms of this chapter and other applicable regulations which apply to uses within the jurisdiction of this chapter. Within the FW, floodway; FF, flood fringe; and GFD, general floodplain districts, all uses not listed as permitted uses or conditional uses in sections 11-101-11, 11-101-13 and 11-101-15 of this chapter, shall be prohibited. In addition:
      1.   New manufactured homes, replacement manufactured homes and certain recreational vehicles are subject to the general provisions of this chapter and specifically section 11-101-21 of this chapter.
      2.   Modifications, additions, structural alterations, normal maintenance and repair or repair after damage to existing nonconforming structures and nonconforming uses of structures or land are regulated by the general provisions of this chapter and specifically, section 11-101-29 of this chapter.
      3.   As built elevations for elevated or floodproofed structures must be certified by ground surveys and floodproofing techniques must be designed and certified by a registered professional engineer or architect as specified in the general provisions of this chapter and specifically as stated in subsection 11-101-23G of this chapter. (Ord. 883, 9-19-2011)