The following sections of the 2018 International Plumbing Code are hereby amended as set forth in this section. Subsequent section numbers used in this chapter shall refer to like numbered sections of the plumbing code:
Section 1101.9 shall be deleted and replaced with the following:
“1101.9 All new storm direct connections to the main shall be cored and installed with a core and T boot.”
Add new section, section 1101.10 as follows:
“All directionally bored storm lines shall be inspected after installation by use of a video camera supplied by the contractor to verify integrity and proper pitch of the pipe. Village inspector to be on site at the time the video is taken.”
Add new section, section 1101.11 as follows:
“All new storm sewer pipe below grade shall be bedded in granular material approved by the village. Granular material is required to be installed to a level 4" above the pipe from a level 2" below the pipe.”
Section 1102 Materials shall be deleted and replaced with the following:
“1102.1 Pipe used for storm water drainage shall be of one of the following materials or approved equal:
Cast iron pipe (hub & spigot) ASTM A74, CISPI HS 74, C564
HDPE polyethylene smooth interior wall plastic pipe ASTM F2648 (for use outside of paved areas only)
Polyvinyl chloride (PVC) SDR 26 ASTM 3034
Polyvinyl chloride schedule 40, ASTM 2665
Concrete pipe, reinforced
Cellular core pipe is not permitted.”
(Ord. 2016-7, 3-28-2016, eff. 7-1-2016; amd. Ord. 2017-1, 2-13-2017; Ord. 2023-14, 5-8-2023)