(A) The secondary plat shall be drawn at a scale no smaller than 100 feet to one inch, with water proof, non-fading India ink on tracing cloth or equally acceptable material.
(B) The secondary plat shall show:
(1) Subdivision names, name and addresses of owner and subdivider, source of title of land as shown by the books of the County Recorder, graphic scale, north point, date and certificate of approval of Plan Commission;
(2) Survey data with certification by a registered professional engineer or land surveyor, showing:
(a) Legal description of the property being subdivided;
(b) Calculated distances and bearings of the subdivision boundaries, lots, lot sizes with total square footage, utility easements, streets, alleys, sidewalks, building setback lines, width of lots at building setback line, lot grades and parcels of reserved or dedicated land for community purposes and total area of the plat;
(c) Location and distances to the nearest established street corners or official monuments and of the streets intersecting the boundaries of the subdivision. Subdivision corners shall be marked with a one inch diameter pipe, 24 inches long, encased in six inch diameter concrete;
(d) Location, type, material and size of monuments;
(e) Vicinity map (small scale) and exact location of subdivision tied to a section corner, township and range;
(f) Lot numbers, street names, house numbers, street light placement and hydrant placement;
(g) Each lot shall bear an elevation notation which is not lower than 16 inches above the top of the curb(s) at the average point of the curb(s) adjoining the lots, related to United States Coast and Geodetic Survey Datum;
(3) Notations as to whether improvements are dedicated or not;
(4) Protective covenants or private restrictions shall be included on the secondary plat or on a separate document recorded with the secondary plat;
(5) Final engineering plans, in addition to the information required for preliminary approval, shall include certification by a certified engineer that storm water design installation shall not damage the land being developed, as well as not damage the adjacent and downstream properties, by certification that reads as follows:
I, the undersigned, state that to the best of my knowledge and belief, the drainage of surface waters will not be changed by the construction of this subdivision, or that if such surface water drainage will be changed, reasonable provision has been made for the collection and diversion of such surface waters into public areas or drains which the subdivider has the right to use, and that such surface waters will be planned for in accordance with accepted standards so as to reduce the likelihood of damage to the adjoining property because of the construction of this subdivision.
(Ord. 1995-2, passed 1-3-95)