(A) The requirements and specifications hereinafter set forth in this section governing the installation and maintenance of gas service lines, house piping, appliance connections, meters and regulators on customer's premises, and the inspection and testing of the same are published by the Commission, for the instruction and guidance of those persons doing gas fitting work. These requirements and specifications have been adopted in the interest of safe and adequate service to the customer.
(B) These requirements and specifications govern service to both newly constructed buildings and to existing structures where any alterations or changes are being made. It shall be the duty of the customer, owner, or his representative to notify the Commission of any changes or alterations, remodeling or reconstruction, or damages to premises affecting gas piping, including meters, regulators, and the customer service line. Gas service shall not be resumed to the premises until all requirements have been met and the lines have been inspected, tested, and approved. When altering or extending house piping or service, all changes shall be made to conform to these requirements and specifications.
(C) It is not intended that these requirements and specifications be all inclusive and where unusual conditions arise or where special service is required, the Commission is to be consulted before proceeding with the work.
(D) The Commission may refuse gas service to any premises where the gas piping does not conform to these requirements and specifications. The Commission will not assume responsibility for any imperfect material or defective or faulty workmanship in the installation of the customer's house piping, appliances or appliance connections, or for any loss or damage arising from such imperfect material or tested by its representative.
(Ord. 19-2011, passed 10-18-2011)