Awnings, marquees, and illuminated business signs with no moving parts are permitted in the industrial (I) district subject to applicable regulations set forth in other ordinances of the county and the following:
A. Maximum Sign Area: The gross area in square feet of all signs on a lot shall not exceed four (4) times the linear feet of street frontage of such lot.
B. Wall Signs: Wall signs are permitted. Projections shall not extend outward more than twelve inches (12") or higher than five feet (5') above the building.
C. Ground Signs: A single ground sign is permitted subject to the following restrictions:
1. It shall be at least twenty feet (20') from any lot line.
2. The maximum height shall be thirty feet (30') above curb level.
3. If located within three feet (3') of a sidewalk or driveway on the lot, it shall have the lowest elevation of the sign face at least twelve feet (12') above the grade of the sidewalk or driveway directly opposite the sign.
D. Awnings: Signs on awnings shall be exempt from the limitations imposed by this chapter on the projection of signs from the face of the wall of any building or structure, provided that any sign located on the awning shall be affixed flat to the surface of the awning and shall not be illuminated. Further, no such sign shall extend vertically or horizontally beyond the limits of said awning.
E. Illumination Permitted: Signs may be illuminated. Such lighting shall comply with the requirements of section 8-5-6, "Structural And Safety Requirements For Signs", of this chapter.
F. Industrial Park Identification Sign: For industrial parks, one additional sign on each street frontage in addition to those regulated above shall be permitted, subject to the following:
1. Content: Such sign shall advertise only the name and location of such industrial park and the name and type of business of each occupant of the park.
2. Area: The gross area in square feet of the additional sign on a lot shall not exceed two hundred (200) square feet or two (2) times the linear feet of street frontage of such lot, whichever is less.
3. Setback: Such a sign shall be set back a minimum of ten feet (10') from the front lot line of such industrial park.
4. Height: Such sign shall conform with the regulations in subsection C of this section. (Ord. 10-001, 1-12-2010)