The Residential Attached Single-Family (“RA”) zone provides areas of the City devoted to attached single-family homes, such as duplexes and townhomes within and complimentary to areas devoted to single-family dwellings to promote a greater mix of residential housing options. The RA Zone includes other complimentary principal and accessory uses by right and as special exceptions. Standards generally applicable to certain uses and dimensional standards can be found in Division III., “Generally Applicable Standards”.
A. Development Standards.
RA STANDARDS | Minimum | Maximum |
RA STANDARDS | Minimum | Maximum |
Lot Size (Sq. Ft.) | 5,400* | N/A |
Lot Width (Ft.) | 40; 24 for units attached on both sides | N/A |
Units per Acre | N/A | 10 |
Front Yard Setback (Ft.) | 20 | N/A |
Side Yard Setback (Ft.) | 8 for each side yard; 0 between attached dwelling units | N/A |
Rear Yard Setback (Ft.) | 20 | N/A |
Building Height (Ft.) | N/A | 40 |
Impervious Lot Coverage (Maximum Percentage of Total Lot Area) | N/A | 60* |
Residential Unit Size (Sq. Ft.) | 900 | N/A |
Accessory Building Location | Rear Yard, min. 8 feet from any lot line - permitted in a side yard only if there is 15 feet between the front building line/front setback and the accessory building | |
Accessory Building Height (Ft.) | N/A | 20 |
Parking Location | Driveway or Garage | |
Signage | Division III., Sec. 10-03-08 | |
Landscaping | Division III., Sec. 10-03-06 | |
Parking | Division III., Sec. 10-03-02 | |
Design Standards | Division III., Sec. 10-03-14 | |
Uses | See Master Use Table above | |
* For attached, single-family townhomes the coverage shall apply for the project as a whole, not the individual lots.
(Ord. 20-29, §2, 9-21-20; Ord. 21-44, §1, 10-4-21)