§ 156.052 MINIMUM LOT SIZE, RESIDENTIAL USES.
   (A)   Except as provided in division (C) below, a lot on which a dwelling is erected may not be smaller in area, in square feet per dwelling unit, than as prescribed as follows.
 
Lot Size in Square Feet
Dwelling Type
R1
R2
R3
R4
B1
B2
A
Multi-family
N/A
N/A
2,400
2,000
N/A
N/A
N/A
Single-family
14,000
10,000
7,200
6,000
6,000
6,000
14,000
Two-family
N/A
N/A
3,600
3,000
N/A
N/A
N/A
 
   (B)   All residential lots shall front a public street and, except as provided in division (C) below, shall have a minimum width along such street as prescribed as follows.
 
Lot Width in Feet
Dwelling Type
R1
R2
R3
R4
B1
B2
A
Multi-family
N/A
N/A
70
70
N/A
N/A
N/A
Single-family
100
75
60
60
6,000
60
100
Two-family
N/A
N/A
60
60
N/A
N/A
N/A
 
   (C)   A single-family dwelling may be located on any lot in any district in which single-family dwellings are permitted if the lot was in separate ownership or included in a recorded subdivision at the time of passage of this chapter even if said lot does not meet the minimum areas or widths specified for the district by this chapter.
   (D)   (1)   The minimum lot areas specified in divisions (A), (B) and (C) above are only for primary uses served by sanitary sewers.
      (2)   Lots not served by sanitary sewers shall be subject to minimum size and area standards established or recommended by the county’s Sanitarian or the state’s Department of Health as required for on-site septic systems. However, in no case shall such lots be less than as prescribed in this section or in § 156.051 of this chapter.
(Ord. 2002-5, passed 7-2-2002)