(A) Land \suitability. Each lot created through subdivision, including planned unit development authorized under § 151.42 must be suitable in its natural site for the proposes use with minimal alteration. Suitability analysis by the city shall include an assessment regarding susceptibility to flooding, existence of wetlands, soil and rock formations with severe limitations for development, severe erosion potential, steep topography, inadequate watery supply or sewage treatment capabilities, near-shore aquatic\conditions unsuitable for water-based recreation, important fish and wildlife habitat, presence of significant historic sites, or any other feature of the natural land likely to be harmful to the health, safety, or welfare of future residents of the proposed subdivision or of the community.
(B) Consistency with other controls. Subdivisions must conform to all official controls of this community. A subdivision will not be approved where a later variance from one or more standards in official controls would be needed to use the lots for their intended purpose. In areas not served by publicly owned sewer and water systems, a subdivision will not be approved unless domestic water supply is available and a sewage treatment system consistent with § 151.36 and § 151.42 can be provided for every lot. Each lot shall meet the minimum lot size and dimensional requirements of § 151.35, including at least a minimum contiguous lawn area, that is free of limiting factors sufficient for the construction of two standard soil treatment systems. Lots that would require use of holding tanks must not be approved.
(C) Information requirements. Sufficient information must be submitted by the applicant for the community to make a determination of land suitability. The information shall include at least the following:
(1) Topographic contours at ten-four intervals or less from United States Geological Survey maps or more accurate sources, showing limiting site characteristics;
(2) The surface water features required in M.S. § 505.02, Subd. 1, to be shown on plats, obtained from United States Geological Survey quadrangle topographic maps or more accurate sources;
(3) Adequate soils information to determine suitability for building and on-site sewage treatment capabilities for every lot from the most current existing sources or from field investigations such as soil borings, percolation tests, or other methods;
(4) Information regarding adequacy of domestic water supply; extent of anticipated vegetation and topographic alterations; near-shore aquatic conditions, including depths, types of bottom sediments, and aquatic vegetation; and proposed methods for controlling stormwater runoff and erosion, both during and after construction activities;
(5) Location of 100-year flood plain areas and floodway districts from existing adopted maps or data; and
(6) A line or contour representing the ordinary high water level, the “toe” and the “top” of bluffs, and the minimum building setback distances from the top of the bluff and the lake or stream.
(D) Dedications. When a land or easement dedication is a condition of subdivision approval, the approval must provide easements over natural drainage or ponding areas for management of stormwater and significant wetlands.
(E) Platting. All subdivisions that create five or more lots or parcels that are two and one-half acres or less in size shall be processed as a plat in accordance with M.S. Chapter 505. No permit for construction of buildings or sewage treatment systems shall be issued for lots created after these official controls were enacted unless the lot was approved as part of a formal subdivision.
(F) Controlled access or recreational lots. Lots intended as controlled accesses to public waters or for recreational use areas for use by nonriparian lots within a subdivision must meet or exceed the sizing criteria in § 151.35.
(Ord. 31, passed - -1995)