The final plat shall be prepared at a scale of one inch = 100 feet in the following numbers: One mylar reproducible stamped “City Copy”, signed; one cloth, stamped “Original”, signed; and two cloth stamped “copy”, signed. The final plat shall be prepared on sheets 20 feet wide and 30 feet in length with a two-foot left borderline and a one-fourth inch top, bottom and right border line. Also include one 11-inch x 17-inch mylar copy of the final plat. The final plat shall include the following information and any other information required by state law:
(A) Data required by state law to fully describe the land to be platted including accurate dimensions, angles, bearings to describe boundaries, streets, easements, areas reserved for public purpose and other important features;
(B) Name and right-of-way width of each street, highway, easement or other rights-of-way as required by state law;
(C) Lot numbers, lot lines and dimensions;
(D) Purpose for which sites, other than residential lots, are dedicated or reserved;
(E) Location of rivers, streams, creeks, lakes, ponds, swamps as required by state law;
(F) Location and description of monuments as required by state law;
(G) Names and location of adjoining subdivision, streets and unplatted properties;
(H) Certification on plat of title showing that the applicant is the owner and a statement by the owner dedicating street, rights-of-way and any other sites for public use;
(I) Certification on plat by surveyor as to the accuracy of survey and plat;
(J) Certification on plat by the City Administrator that the plat has been approved for recording in the office of the County Recorder;
(K) Certification that the subdivider has complied, when so required by the city, with one of the following alternatives shall be submitted with the final plat:
(1) All the improvements have been installed in accordance with the requirements of these regulations;
(2) A bond has been posted with the city which is in an amount determined by the Council to be sufficient to these regulations, is with a surety satisfactory to the Council, and which specifies the time for completion of the improvements and installations; or
(3) A subdivision agreement will be signed by the subdivider and the city relative to improvements and appurtenances to the plat.
(L) Cross-sections, profiles and grades of streets, bicycle/pedestrian paths, curbs, gutters and sidewalks showing locations of in-street utilities, and drawn to standard scales and elevations shall be submitted with the final plat, when improvements are installed under division (K)(1) or (2) of this section;
(M) Protective covenants, if any, shall be submitted with the final plat; and
(N) Letters of approval of highway access points and service roads from the Commissioner of the Department of Transportation and the County Engineer, as applicable, shall be submitted with the final plat.
(Ord. 232, passed 11-1-2000)