The storage of contractor's construction equipment and supplies in the Limited Industrial District shall be permitted only if:
(A) The contractor's main office is located on the same lot or immediately adjacent to the lot on which the construction equipment and supplies will be stored; and
(B) The contractor's construction equipment and supplies are stored, maintained and repaired in an accessory structure or structures which are fully enclosed on at least 3 sides and screened from public view on the fourth side unless enclosed. The Planning Commission may waive or modify the requirement for storage, maintenance, and repair of contractor's equipment and supplies within an accessory structure where:
(1) It can be determined that the reduction or elimination will not adversely impact adjoining properties; and
(2) the Planning Commission approves an alternate screening plan; and
(3) Storage, maintenance, and repair is located and conducted to the rear of the principal structure and screened from the public way.
(C) The storage structure(s) on any lot shall not exceed a .25 floor/area ratio for the lot on which it is located and in no event shall the storage structure area exceed 25,000 square feet. The storage building shall comply with the setback requirements for principal structures in the LI District and shall meet all other criteria of this Code for accessory structures in the LI District.
(Ord. 90-46-644, 11-20-1990; Ord. 08-26-502, 10-14-2008; Ord. 11-25-591, 10-27-2011; Ord. 14-23-678, 11-13-2014)