In addition to the requirements found in § 152.06 for development in flood fringes, regulatory floodways and SFHA or flood plains where no floodways have been identified (Zones A, AO, AH, AE, Al-A30, A99, VO, V1-30, VE, V, ME or E), the following requirements shall be met:
(A) Public health standards;
(B) No development in the SFHA shall include locating or storing chemicals, explosives, buoyant materials, animal wastes, fertilizers, flammable liquids, pollutants or other hazardous or toxic materials below the FPE;
(C) New and replacement water supply systems, wells, sanitary sewer lines and on-site waste disposal systems may be permitted providing all manholes or other above ground openings located below the FPE are watertight;
(D) Carrying capacity and notification; (For all projects involving channel modification, fill or stream maintenance, including levees, the flood carrying capacity of the watercourse shall be maintained. In addition, the village shall notify adjacent communities, in writing, 30 days prior to the issuance of a permit for the alteration or relocation of the watercourse.)
(E) All buildings located within a 100-year flood plain also known as a SFHA shall be protected from flood damage below the flood protection elevation. However, existing buildings located within a regulatory floodway shall also meet the more restrictive appropriate use standards included in § 152.06(B). This building protection requirement applies to the following situations:
(1) Construction or placement of a new building;
(2) Structural alteration to an existing building that increase the floor area by more than 20% or the market value by more than 50%;
(3) Installing a manufactured home on a new site or a new manufactured home on an existing site. This building protection requirement does not apply to returning a manufactured home to the same site it lawfully occupied before it was removed to avoid flood damage;
(4) Installing a travel trailer on a site for more than 180 days; and
(5) This building protection requirement may be met by one of the methods provided for.
(F) A residential or non-residential building, when allowed, may be constructed on permanent land fill in accordance with the following:
(1) The lowest floor, including basement, shall be at or above the flood protection elevation.
(2) The fill shall be placed in layers no greater than one foot deep before compaction and should extend at least ten feet beyond the foundation of the building before sloping below the flood protection elevation. The top of the fill shall be above the flood protection elevation. However, the ten-foot minimum may be waived if a structural engineer certifies an alternative method to protect the building from damages due to hydrostatic pressures. The fill shall be protected against erosion and scour. The fill shall not adversely effect the flow or surface drainage from or onto neighboring properties.
(G) A residential or non-residential building may be elevated in accordance with the following:
(1) The building or improvements shall be elevated on crawl space, walls, stilts, piles or other foundation that is permanently open to flood waters and not subject to damage by hydrostatic pressures of the base flood or 100-year frequency flood. The permanent openings shall be no more than one foot above grade, and consists of a minimum of two openings. The openings must have a total net area of not less than one square inch for every one square foot of enclosed area subject to flooding below the base flood elevation.
(2) The foundation and supporting members shall be anchored and aligned in relation to flood flows and adjoining structures so as to minimize exposure to known hydrodyamic forces such as current, waves, ice and floating debris.
(3) All areas below the flood protection elevation shall be constructed of materials resistant to flood damage. The lowest floor, including the basement, and all electrical, heating, ventilating, plumbing and air conditioning equipment and utility meters shall be located at or above the flood protection elevation. Water and sewer pipes, electrical and telephone lines, submersible pumps and other waterproofed service facilities may be located below the flood protection elevation.
(4) No area below the flood protection elevation shall be used for storage of items or materials.
(5) Manufactured homes and travel trailers to be installed on a site for more than 180 days shall be elevated at or above the flood protection elevation and anchored to resist flotation, collapse or lateral movement by being tied down in accordance with the rules and regulations for the Illinois Mobile Home Tie-Down Act issued pursuant to 77 Ill. Adm. Code 870.
(H) Only a non-residential building may be structurally dry floodproofed, in lieu of elevation; provided that, a registered professional engineer shall certify that the building has been structurally dry floodproofed below the flood protection elevation, the structure and attendant utility facilities are watertight and capable of resisting the affects of the base flood or 100-year frequency food; and (The building design shall take into account flood velocities, duration, rate of rise, hydrostatic and hydrodyamic forces, the effects of buoyancy and impacts from debris or ice. Floodproofing measures shall be operable without human intervention and without an outside source of electricity, Levees, berms, floodwalls and similar works are not considered floodproofing for the purpose of this division.)
(I) Non-conforming structures located in a regulatory floodway may remain in use, but may not be enlarged, replaced or structurally altered. A non-conforming structure damaged by flood, fire, wind or other natural or man-made disaster may be restored unless the damage exceeds 50% of its market value before it was damaged, in which case it shall conform to this chapter.
(1981 Code, § 30.09) (Ord. 90-5, passed - -)