A. Final plats and profiles shall show:
1. Boundaries of the subdivision with accurate dimensions and bearings and the location and description of all monuments.
2. Municipal, county and section lines when intersecting the property.
3. Location, width, and names of all existing or platted streets, or other public ways, and easements within and adjacent forty feet (40') to the tract.
4. Location and accurate dimensions of all proposed streets, alleys, blocks, lot lines, easements and areas to be dedicated for parks, playgrounds and schools.
5. Plans and profiles of each proposed and established street, road, or alley on the center line of the roadway.
6. Plans and profiles of all proposed sanitary and storm sewers with gradients and pipe sizes.
7. Plans and profiles of proposed water distribution systems showing pipe sizes and the location of all valves and fire hydrants.
8. All radii, chords, points of curvature, points of tangency, bearings of tangents, central angles and length and degree of curves.
9. Names of all streets.
10. Block and lot numbers.
11. Description of property subdivided showing location and extent.
B. The information required under subsections A5, A6, A7, and A8 of this section shall be shown on separate drawings accompanying the final plat and properly certified. (Ord., 12-5-1961)
C. Subsections A1 to and including A5 shall be prepared by a registered surveyor and subsections A6 to and including A11 of this section shall be prepared by a registered engineer. In both instances, the drawings shall bear the official registration seal of the surveyor or engineer. (Ord., 12-5-1961; amd. 2001 Code)
D. Where the subdivider does not propose to dedicate land for streets, alleys or other public uses (except easements for utilities), the information required by subsections A4, A5, A6, A7 and A8 of this section shall not be required. (Ord., 12-5-1961)