(A) Lot arrangement shall be so that there will be no foreseeable difficulties, for reasons of topography or other conditions, in securing building permits to build on all lots in compliance with Chapter 152. Provisions shall be made for driveway access to all lots from an approved street at a proper distance from intersecting streets.
(B) Lot dimensions shall comply with the minimum requirements of Chapter 152. Lot size, width, depth, shape, grade, location and orientation shall be in proper relation to street and block design and to existing and proposed topographical conditions.
(C) Through lots shall be avoided except where necessary to provide separation of residential development from traffic arterials or to overcome specific disadvantages of topography and orientation.
(D) A subdivider shall be required to furnish and install fences wherever the Plan Commission determines a hazardous condition may exist. The type of fencing material and height shall be noted on the final plat.
(E) A no-access screened buffer strip of ten feet shall be provided along lot lines adjoining an adverse influence or an arterial street or highway, if required by the Plan Commission. This requirement shall be noted on the final plat.
(F) Corner lots shall be sufficiently larger than interior lots to allow proper setback from both streets. Side lines of lots shall be approximately at right angles to the street lines.
(G) Lots shall be laid out so as to provide positive drainage away from all buildings. Individual lot drainage shall be coordinated with the general storm drainage pattern for the area and drainage shall be designed so as to avoid concentration of storm water drainage from one lot to adjacent lots. Where possible, drainage should be contained on each lot or parcel.
(Ord. 83-003, passed 4-12-1983)