§ 153.45 SPECIFICATIONS.
   The following specifications are hereby declared to be a part of this chapter:
   (A)   Appendix. LOT AND YARD REQUIREMENTS. The Appendix, LOT AND YARD REQUIREMENTS, shows the minimum lot areas, area per unit, ground floor areas, lot widths, front yard depths, rear yard depths, side yard widths, and maximum building height limits, lot coverage for the various districts. The Appendix follows this Zoning Code.
   (B)   Flood Insurance Criteria and Maps. The Flood Plain districts (areas subject to inundation by the regulatory flood) as identified by the Federal Insurance Administration on the Fayette County Flood Insurance Rate Map dated June 22, 1979, and on the City of Connersville Flood Insurance Rate Map dated November 23, 1973, Revised June 11, 1976, along with any subsequent revisions to the text of the federal criteria or maps, and all NFIP regulations (contained in CRF 44, Chapter 60 3(d) and as specified on attachment A (Section 10 Review Sheet for NFIP Regulations) are adopted by reference and are on file for public examination in the Plan Commission Office in the Fayette County Court House. (See § 153.02)
   (C)   Construction Standards.
      (1)   Any new development or redevelopment within the City of Connersville or the jurisdiction of the Fayette County Area Plan Commission shall be designed and constructed in accordance with the Construction Standards of Fayette County and the City of Connersville, which are hereby adopted by reference and are on file for public examination in the Area Planning Office in the Fayette County Court House.
      (2)   The approving agency for the Comprehensive Plan shall be the Fayette County Commissioners or the Connersville Board of Works and Safety.
      (3)   The entire set of full size standards shall be attached to the construction drawings and shall be considered part thereto. Partial set may be used for small projects when approved by the Fayette County APC.
      (4)   Individual standards that do not apply may be crossed out by the Design Engineer through the placement of a single large X over detail. Minor reference notations may be placed adjacent to individual standard titles for coordination; however, the standards themselves shall not be modified in any way.
      (5)   Details prepared by outside sources covering work which is not covered by standards are the sole responsibility of the Design Engineer and shall be placed on sheets other than these standard sheets.
      (6)   All subdivision development proposed to the Fayette County APC must use the urban right- of-way guidelines for all interior subdivision streets.
      (7)   Contractor shall verify the exact location of all existing utilities at least 48 hours prior to any construction or excavation. During construction, all utilities shall be adequately supported to minimize damage. The contractor shall be responsible for repairing or replacing damaged utilities to the satisfaction of the approving agency and the owner of the affected utility.
      (8)   All other information and standards should be followed as per adopted and amended in the May 31, 2002 Construction Standards.
(Ord. 3095, passed 2-15-93; Am. Ord. 4218, passed 7-15-02)