(A) Generally. The developer or owner shall cause record drawings to be prepared and submitted to the Administrator for all streets, drainage ditches and facilities, utility pipes and structures, and finished grade elevations for the project. Said record drawings shall be filed with the Administrator prior to the release of any performance assurances. The record drawing plans shall be accompanied by a certificate of completion and compliance properly executed in the form prescribed by the Commission by the licensed engineer or surveyor preparing the site plan and/or record drawings. Record drawings, including the approved final plat, shall be submitted in the forms specified by the Plan Commission.
(B) General requirements. Plans are to contain a certification statement that the improvements have been installed in reasonable compliance with the original design plans with respect to horizontal locations and grades and any deviations of locations, grade, or material used are shown in these record drawings. Said certification is to be sealed and signed.
(C) Specific requirements.
(1) Grading on site plan(s). Grades:
(a) Major drainage swales and percents of slope;
(b) Pad grades;
(c) Street grades;
(d) Centerline and curb if street is bituminous pavement with concrete curb. Centerline only if streets are concrete and placed with electronic control. (Maximum 50 foot spacing.);
(e) All sag and crest points;
(f) Paved swales, if any, at 50 foot intervals;
(g) Lake or pond if applicable; and
(h) Locations of sidewalk ramps.
(2) Plan and profiles.
(a) Sanitary sewers.
1. Invert elevations and percents of slope;
2. Top of casting elevations;
3. Lateral locations based on distances along main from manholes;
4. Locations of each manhole or structure (to make sure they are sufficiently within designated easements to permit future excavation to system if needed); and
5. Designate any material change from design plans, where plans show any alternatives, indicate alternative actually used.
(b) Storm sewers.
1. Invert elevations and percent of slope;
2. Top of casting elevations;
3. Location of pipe and structures (to make sure they are within designated easements); and
4. Designate any material change from design plans, where plans show any alternatives, indicate alternate actually used.
(c) Streets.
1. Grades;
2. All low and high points;
3. All percents of slope;
4. Any deviation of alignment; and
5. Grades and dimensions on acceleration and deceleration lanes if applicable.
(Ord. 2014-26, passed 9- -2014) Penalty, see § 156.999