Manufactured and modular homes shall be allowed in R-1, R-2 and R-3 districts, provided that such homes meet the definitions of same in section 10-2-1 of this title, as applicable, and provided further that all of the following requirements are met: (Ord. 339, 6-20-1996; amd. Ord. 525, 5-1-2007)
A. The manufactured or modular unit be on a permanent cement block masonry or concrete foundation with an enclosed crawl space or basement.
B. The unit be fully sided with conventional residential siding.
C. The unit have a hip or gabled asphalt, fiberglass or equivalent roof with nominal roof pitch of 3/12 minimum.
D. That there be no more than one housing unit per lot, and that the unit be a single-family residential dwelling.
E. The lot on which the unit is located is owned by the owner of the manufactured or modular home.
F. The dwelling unit conform to lot line, setback and any other property development standards or requirements in the applicable zoning district for site built housing.
G. The shortest outside dimension of the structure be no less than twenty four feet (24').
H. The structure must be multisection units in which the length does not exceed four (4) times the width.
I. That there be a minimum of ten inches (10") eave overhang, including guttering where applicable. In R-1 districts, the side of the structure with the widest dimension must face the street.
J. The owner shall understand and stipulate that the structure is real property and shall be taxed as such. (Ord. 339, 6-20-1996)