1129.04 STREET DESIGN AND STANDARDS.

   The arrangement, character, extent, width, grade construction and location of all streets shall conform to all appropriate Major Thoroughfare Plans or subsequent amendments thereto, and shall be considered in their relation to existing and planned streets, topographical conditions and public convenience and safety, and in their appropriate relation to the proposed uses of the land to be served by such streets. The street pattern shall discourage through traffic in the interior of a subdivision. The subdivider shall provide within the boundaries of the subdivision plat the necessary right of way for the widening, continuance or alignment of such streets in conformity with Major Thoroughfare Plans.

   The design and improvement standards contained in Table 1 herein are suggested minimums. All streets shall be designed and constructed in accordance with standards as specified.

   All thoroughfare entrances and exits to and from any new subdivision within the City must have minimum right-of-way widths of fifty feet and minimum paved surface widths of twenty-six feet. (Ord. 74-77. Passed 12-27-77.)

TABLE 1

STREET DESIGN STANDARDS

(in feet)

	Cul-de-sac and Loop Streets			Local Streets			Collector Streets
Design Element	*Low Density	Med Density	High Density	Low Density	Med Density	High Density	Low Density	Med Density	High Density
Right of way	50	50	60	50	60	60	60	60	80
Pavement width	26	26	36	26	32	36	32	36	36
Sidewalk width	4	4	4	4	4	4	4	4	4
Maximum cul-de-sac length	700	700	700	-	-	-	-	-	-
Minimum cul-de-sac radius
Right-of-way	50	55	55	-	-	-	-	-	-
Minimum cul-de-sac radius
Pavement	40	40	40	-	-	-	-	-	-
Minimum center line radius of streets with an angle of turn of:
(1) Between 80 degrees and 100 degrees	60	60	60	60	60	60
(2) Less than 80 degrees or more than 100 degrees	200	200	200	200	200	200

A utility easement ten feet in width may be required along each side of the street right of way.

Note:    Exceptions to the standards contained in this table are permitted under certain conditions for large lots, see Sections

    1129.11 and 1129.12. For variance procedures see Section 1133.05 .

   *Low, Medium and High refer to proposed density of development.

    (Ord. 70-74. Passed 10-15-74; Ord. 75-77. Passed 12-27-77.)