Subd. 1. Purpose. The purpose of the I-2, General Industrial District is to provide areas suitable for the location of general industrial activities, including manufacturing and other such activities which, because of the nature of the product or character of operation, require isolation from or special protections for non-industrial uses.
Subd. 2. Uses. Uses allowed within the district are as described in subsection 1003.05.
Subd. 4. Lot Area, Height, and Setback Requirements. The following minimum requirements shall be observed in the I-2 District subject to additional requirements, exceptions, and modifications set forth in this chapter.
Table 13 | |
I-2, GENERAL INDUSTRIAL DISTRICT*
|
Table 13 | |
I-2, GENERAL INDUSTRIAL DISTRICT*
| |
Maximum building coverage | 50% |
Minimum lot area | 40,000 square feet |
Minimum lot width | 100 feet |
ACCESSORY STRUCTURE SETBACKS | |
Front | Allowed by CUP |
Rear | 10 feet |
Side | 10 feet |
PARKING SETBACKS | |
Front | 10 feet |
Rear | 5 feet |
Side | 5 feet |
Structure and parking setback adjacent to R District | 20 feet |
PRINCIPAL STRUCTURE SETBACKS | |
Front | 40 feet |
Railroad right-of-way | 10 feet |
Rear | 30 feet |
Side | 20 feet |
Wetland setback and buffer | 30 feet |
BUILDING HEIGHT | 35 feet |
ACCESSORY BUILDING HEIGHT | 17 feet |
IMPERVIOUS SURFACE COVERAGE | 85% |
Note to Table: * All uses located within the Shoreland Overlay District are subject to the standards in subsection 1004.03 | |