§ 1003.15 I-1, Industrial Park District.

   Subd. 1.   Purpose. The purpose of the I-1, Industrial Park District is to provide for the establishment of warehousing and light industrial development. The overall character of the I-1 District is intended to have an office/warehouse character, thus industrial uses allowed in this district are limited to those which can compatibly exist adjacent to both lower intensity business uses and high intensity manufacturing uses.

   Subd. 2.   Uses. Uses allowed within the district are as described in subsection 1003.05.

   Subd. 3.   Uses Standards. Uses are subject to the applicable provisions of the performance standards in Section 1006 and the process requirements in Section 1002.

   Subd. 4.   Lot Area, Height, and Setback Requirements. The following minimum requirements shall be observed in the I-1 District subject to additional requirements, exceptions, and modifications set forth in this chapter.

Table 12
I-1, INDUSTRIAL PARK DISTRICT*
Minimum lot area	40,000 square feet
Minimum lot width	150 feet
PRINCIPAL STRUCTURE SETBACKS
Front	40 feet
Railroad right-of-way	10 feet
Rear	20 feet
Side	20 feet
Wetland setback and buffer	30 feet
ACCESSORY STRUCTURE SETBACKS
Front	Allowed by CUP
Rear	10 feet
Side	10 feet
PARKING SETBACKS
Front	10 feet
Rear	5 feet
Side	5 feet
Structure and parking setback adjacent to R District	20 feet
BUILDING HEIGHT	35 feet
ACCESSORY BUILDING HEIGHT	15 feet
IMPERVIOUS SURFACE COVERAGE	85%
Note to Table: *   All uses located within the Shoreland Overlay District are subject to the standards in subsection 1004.03