§ 1003.08 R-2, Medium Density Residential District.

   Subd. 1.   Purpose. The purpose of the R-2, Medium Density Residential District is to provide for low to medium density development through the mixture of single, two unit, and townhome dwellings and directly related, complementary uses. Development of two-family and single-family detached residential dwelling units and directly related, accessory, and complementary uses.

   Subd. 2.   Uses. Uses allowed within the district are as described in subsection 1003.05.

   Subd. 3.   Uses Standards. Uses are subject to the applicable provisions of the performance standards in Section 1006 and the process requirements in Section 1002.

   Subd. 4.   Lot Area, Height, and Setback Requirements. The following minimum requirements shall be observed in the R-2 District subject to additional requirements, exceptions, and modifications set forth in this chapter.

TABLE 5
R-2, MEDIUM DENSITY RESIDENTIAL DISTRICT *
	Requirements
SINGLE-FAMILY
Maximum height principal structure	35 feet
Minimum lot area	8,000 square feet
Minimum lot width	60 feet
Principal Structure Setbacks
Front	25 feet
Minimum setback between buildings	10 feet
Rear	25 feet
Side	10 feet
TWO UNIT/TOWNHOME UNIT
Maximum height principal structure	35 feet
Minimum base lot area	12,000 square feet
Minimum base lot width	100 feet
Principal Structure Setbacks
Front	25 feet
Minimum setback between buildings	10 feet
Rear	25 feet
Side	10 feet (0 lot line setback interior unit)
OTHER USES
Maximum height principal structure	35 feet
Minimum lot area	20,000 square feet
Minimum lot width	100 feet
Principal Structure Setbacks
Front	50 feet
Rear	40 feet
Side	20 feet
ALL USES
Arterial road	50 feet
Collector road	45 feet
Railroad setback	100 feet
Residential driveway setback	5 feet
Wetland setback and buffer	30 feet (from delineated boundary)
Note to Table: *   All uses located within the Shoreland Overlay District are subject to the standards in subsection 1004.03