18.100.080   DEVELOPMENT AREA NOS. 2, 5 AND 9.
   These development areas provide for the orderly development of detached single-family residences on minimum five thousand (5,000) square foot lots (see Exhibit No. 28 of the Specific Plan).  The standards of the "RS-3" Single-Family Residential Zone in Chapter 18.04 (Single-Family Residential Zones) shall apply, except as otherwise provided below:
   .010   Minimum Building Site and Building Pad Area.  The minimum building site shall be five thousand (5,000) square feet, and the minimum building pad area shall be four thousand (4,000) square feet.
   .020   Minimum Lot Width and Frontage.  All lots shall have a minimum width of not less than forty-five (45) feet.
   .030   Minimum Lot Width for Cul-de-Sac and Knuckle Lots.  The minimum lot width for cul-de-sac and knuckle lots shall be forty (40) feet, measured at the building setback.
   .040   Minimum Lot Frontage Width of Flag Lots.  The minimum lot frontage width at right-of-way shall be twenty (20) feet.
   .050   "Front-On" Garages.  The minimum setback to any “front-on” garage shall be not less than twenty (20) feet, with a roll-up garage door.  However, at least fifty percent (50%) of setbacks to “front-on” garages located on the same block shall be twenty-five (25) feet or more.
   .060   Minimum Dimensions of Parking Spaces.  Required open parking spaces shall be permitted in a driveway having minimum dimensions of sixteen (16) feet wide and twenty (20) feet long, measured from the garage door to the nearest edge of the pedestrian walkway or property line, whichever is the lesser distance.
   .070   Required Site Screening.  Except as otherwise provided herein, a solid, decorative-type, masonry wall, landscaped earthen berm, or any combination thereof, totaling not less than six (6) feet in height, shall be provided along, and immediately adjacent to, the site boundary line of any single-family development abutting any arterial highway or any commercial or multiple-family zone boundary, or any alley abutting any such boundary.  The height of any such wall and/or berm shall be as measured from the highest finished grade level of the building pad of the dwelling units located nearest any such abutting boundary.
   However, in conditions where a grade separation between any arterial highway and property line occurs at a minimum of six (6) feet, and a minimum setback of twelve (12) feet exists between the single-family development and conditions as stated above, an open, decorative-type wall is permitted, in order to allow and preserve view opportunities.
   .080   Coverage and Open Space Requirements.  The maximum coverage by all residential and accessory buildings shall be forty percent (40%) of the lot area.  (Ord. 4937 § 1; July 12, 1988:  Ord. 5920  § 1 (part); June 8, 2004.)