Any building supported communication tower located in any district shall meet all of the required development standards set forth in this section:
1. Prior to issuing a building permit, the following must be on file with the City Building Inspection Department:
A. General placement diagram
B. Manufacturer’s specifications
C. Wind stress information.
2. Towers and antenna may not be more than 30 feet above the utmost point of building contact with an additional 25 feet for multiple antenna connections.
3. The tower is to be strapped at least every five feet to said building or per manufacturer’s instructions. The tripod type is to be attached via connection to the building’s main structures.
4. An anti-climbing apparatus is to be installed to prevent unauthorized ascension on all communication towers except All Band Vertical Antennas.
5. The tower is to be grounded per manufacturer’s recommendations.
6. There is to be an angular clearance of communication tower height from tip to top building support plus 15 feet to any neighboring domicile, overhead lines, or buildings and shelter buildings located on recreational facilities.
7. Only two radio communication support towers per residential location, with only one located per building side. They may not be located in the front yard.
8. Transmission lines must meet municipal requirements on installation.
9. The building supported communication tower including any guy wires, anchors, supporting structures, and accessory equipment shall be located and designed so as to minimize the visual impact on surrounding properties and from public streets.
10. The building supported communication tower shall be removed upon the termination or revocation of the permit. The permit shall terminate on the sale or transfer of ownership of the property by the applicant.
11. All building supported communication tower shall be maintained in good condition and in accordance with all requirements of this section.
12. All building supported communication tower shall be subject to periodic re-inspection. No additions, changes, or modifications shall be made to an antenna, unless the addition, change or modification is in conformity with the Building Code.
13. The applicant shall present documentation of the possession of any required license by any Federal, State, or local agency.
14. The owner of such a structure shall assume complete liability in case of personal or property damage.
15. Failure to abide by and faithfully comply with this section or with any and all conditions that may be attached to the granting of any building permit shall constitute grounds for the revocation of the permit by the City.